• The CoPilot kit already has the receiver “learned” to the ID number of the remote it is packaged with.
• To “learn” the ID number of additional remotes, follow these steps:

1. Press and hold the LEARN button located on the side of the receiver (receiver will emit a continuous tone.)
2. Press any button on the remote (receiver will beep 4 times confirming that it has “learned” the ID number of the remote and that the programming is valid and complete.)

• “Re-learning” the ID number of the same remote will not overwrite previously “learned” remotes.
• If the receiver has “learned” the ID number of ten remotes, “learning” an eleventh remote will erase or over write the first “learned” remote.
• The CoPilot allows the angler to erase all stored remote ID numbers fro the receiver. To do so, follow these steps:

1. Remove power from the receiver by unplugging the receiver from the motor.
2. Press and hold the LEARN button and power up the receiver by plugging it back into the motor. Hold the learn button down for 10 seconds.
   During this time the receiver audio will emit a warble sound, slowly transitioning to a constant beep, and then shut off.
3. Release the LEARN button and the receiver will reboot. The receiver will chirp 4 times followed by a 1 second long beep indicating memory is empty. This audio pattern will occur each time the receiver powers up until a remote ID number is learned.

No, CoPilot is designed only for electric steer motors.

No, there are no adapter cables for the CoPilot accessory.

If the plug from the CoPilot and the trolling motor don’t match, you have purchased the wrong CoPilot.

CoPilot: Yes, you can use up to ten remotes simultaneously.

i-Pilot: Yes, you can use unlimited remotes simultaneously.

i-Pilot Link: Yes, you can use up to four remotes simultaneously.

Talon: Yes, you can use up to ten remotes simultaneously.

All remotes are sealed, making them splash proof and they do float.